FX No Limit 1″ Rings, Weaver75

The FX No Limit 1″ Rings for Weaver rails solve a problem every serious airgunner eventually faces: running out of scope elevation adjustment. FX Airguns designed these adjustable mounts to let you correct barrel droop and scope alignment without shims or compromised optics. Shooters across Finland, Germany, France, Spain, and the Netherlands rely on these rings for break-barrel springers and long-range PCP setups. If you need FX No Limit 1″ Rings Weaver price, FX No Limit 1″ Rings Weaver reviews, or want to find FX No Limit 1″ Rings Weaver for sale, these mounts deliver proven vertical and angle adjustment. The 1-inch tube diameter suits most standard airgun scopes, while the Weaver/Picatinny base fits a wide range of rifles. These rings provide 0.17 inches of vertical adjustment and +/- 1.5 degrees of angle correction. At 100 metres, that vertical shift translates to roughly 4 metres of point-of-impact change. Overall height ranges from 0.915″ to 1.085″. Each ring features three screws: one for the base clamp, one for height and angle adjustment, and two for the ring caps. The design lets you rough-zero the scope optically centred, then fine-tune with turrets. Weight is approximately 4.2 oz per set, and the Weaver clamp uses a large hex nut for secure mounting.

The primary benefit is keeping your scope near its optical centre. Standard rings force you to dial elevation turrets far from neutral, reducing image brightness and limiting adjustment range. The No Limit rings let you correct mechanical misalignment at the mount itself. This proves invaluable for break-barrel springers where barrel-to-receiver angles often deviate. One screw per mount handles both height and angle adjustment, simplifying setup. Owners report the rings work brilliantly for correcting barrel droop and achieving bright, centred optics. However, forum feedback reveals important concerns. Multiple owners report breakage at the base clamp screw, with one user stating their rings “broke in the same spot” on two separate sets. Zero retention problems appear in some reports, with one owner noting their rings “lost zero for the third time” as ring cap screws loosened repeatedly. Proper torque is critical: 45 in-lbs for Weaver base screws, 35 in-lbs for adjustment screws, and 15 in-lbs for ring caps. Rounded receivers cause fitting issues, and one user broke a base because the mount sat on the receiver curve rather than seating in the rail grooves.

Correct installation determines performance. Before torquing, verify the base sits flush in the rail grooves. If it rests on a rounded receiver, stop immediately. Use a torque wrench and follow the recommended values. Optically centre your scope first, then adjust the mounts for rough zero, and finally use turrets for fine zero. This preserves image brightness and maximises available adjustment. For break-barrel springers, these rings effectively correct barrel droop that fixed mounts cannot address. Pair the rings with quality 1-inch scopes from Element Optics, Hawke, or Vortex. Order the FX No Limit 1″ Rings Weaver from Airgun Store today. Each set includes two rings with all mounting hardware. We recommend a quality torque wrench for proper installation. For shooters in Finland, Germany, Italy, Spain, and across the Eurozone, these rings solve elevation issues on both springers and PCP rifles. Contact us to confirm stock and discuss your mounting requirements.